Follow the below instructions to connect your Auric One device to your home Wifi network:

  1. Ensure the device is turned on, and the LED on the top of the unit is glowing WHITE / BLUE.

  2. Go to wifi settings and select the following network from the list of available networks → *AP-AURIC-####* (i.e. if using AURIC-1021, then network is AP-AURIC-1021)

    image.png

  3. After your phone connects to this wifi network, navigate to Safari (or other web browser) and type in either of the following addresses → http://auric-####.local (i.e. if using AURIC-1021, then address is http://auric-1021.local), or http://192.168.4.1

image.png

  1. This will open the wifi setup page. Select your home wifi network from the drop down menu. If you don’t see it here then press the “Refresh Network List” button. Note: pressing this button may sometimes disconnect your phone from the *AP-AURIC-10##* wifi network. If it does, please go back to step (2) above.

image.png

  1. Press “Save Credentials” and your device will restart and connect to your home wifi network. If successful, the unit light will glow GREEN for a few seconds and then turn off.

image.png

  1. Follow instructions at www.auric.au/pilot-program for the remaining device setup instructions

You can also watch this Loom video for a step-by-step runthrough.